The Kubota DPF Emulator is a device that completely removes the DPF system of your Kubota vehicle. With this emulator, you canremove all DPF errorsfrom your vehicle. You can even completely remove the DPF filter to relax the vehicle’s exhaust system.

Kubota is a major engine manufacturer. As such, it has a wide range of forklifts and work vehicles. This series of forklifts has 2 models that use AdBlue fluid instead of AdBlue liquid.
Troubleshooting exhaust system malfunctions on Kubota models that only have a DPF is very simple.

The Kubota DPF emulator simulates sensors Temperature 1, Temperature 2, Temperature 3, and differential pressure sensors DPF.
Using a Kubota DPF emulator is a quick and reliable solution.
The Kubota Exhaust Temperature 1, Exhaust Temperature 2, and Exhaust Temperature 3 sensors are easily distorted because they are located on the exhaust. Failure of one of these components will result in a loss of torque from your vehicle.

A Kubota DPF failure will limit vehicle torque and lead to vehicle failure.
A Kubota pressure sensor error can often be caused by errors caused by an overloaded DPF in your vehicle. Using the Kubota DPF emulator eliminates vehicle torque limitation, reducing time, costs, and labor.

Use the DPF emulator to correct temperature sensor errors and completely prevent malfunctions by simulating the exhaust system. The Kubota DPF is located in the exhaust outlet and between the Kubota DPF pressure sensors. The Kubota DPF has very small pores. Therefore, it was used to reduce dirty air passing through the exhaust to meet emission standards.

Because the Kubota DPF has very low porosity, it can become clogged with soot in approximately 4 hours. Due to the soot level of the Kubota DPF filter, the vehicle will be inoperable and may eventually fail due to torque limitation. In the event of a power outage, the DPF must be removed and cleaned by authorized personnel. This results in significant costs and wasted time. It is enough to use the Kubota DPF emulator to root errors such as the DPF error and temperature sensor.

After this, the DPF screen will be blank, and the DPF will remain clean. No warnings or errors will appear on the DPF screen. With the Kubota DPF emulator, you will not receive an exhaust system warning. There will be no errors for the Kubota temperature sensors, differential pressure sensor, or DPF filter. Furthermore, sensors removed after installation could be recovered.

Components simulated by the Kubota DPF Emulator:

• 3x Exhaust Gas Temperature Sensor
• 1x DPF Pressure Sensor

DPF Emulator Supported Models:

• All vehicles with Kubota engines with a diesel particulate filter
• Hyster Forklift
• Yale forklift
• D1803
• V2403
• V2607
• V3307
• V3800
• V6108 Cars