CASE Excavator loaders are equipped with a CASE Excavator NOx sensor, a CASE Excavator temperature sensor, and a CASE Excavator differential pressure sensor because the loaders use AdBlue and comply with that standard.
The CASE Excavator NOx sensor is a sensor on the exhaust side of CASE Excavator vehicles. The NOx sensor can often fail due to its location. A failure of the CASE Excavator NOx sensor causes a restriction in the system. The vehicle operates due to the resulting restriction, but is unable to achieve sufficient power and torque. The CASE Excavator AdBlue Emulator will help you troubleshoot the problem.
CASE Excavator Adblue Emulator is the best solution for NOx sensor, temperature sensor, differential pressure sensor, and DPF errors.
The CASE Excavator differential pressure sensors are located before and after the CASE Excavator DPF. If your vehicle’s DPF becomes damaged or clogged, CASE Excavator vehicles will receive a fault notification.
This warning will prompt users to replace or clean the DPF, depending on the situation. At the same time, depending on the DPF filter’s condition, the CASE Excavator differential pressure sensors inform the vehicle’s ECU.
The CASE Excavator adblue emulator will provide you with solutions in the event of a clogged DPF or differential pressure sensors. This will ensure your vehicle operates at full capacity even if the NOx sensor and temperature sensor are damaged or temporarily out of order.

Cancelled areas with the CASE excavator emulator:

• NOx sensors
• diesel particulate filter
• differential pressure sensor
• AdBlue level
• temperature sensors

Compatible models:

Crawler excavators

• CX130D
• CX160D
• CX180D
• CX210D
• CX240D
• CX250D
• CX300D
• CX350D
• CX370D
• CX490D
• CX750D

Midi excavators

• CX75C
• CX80C