DESCRIPTION

Webasto Thermo Test (with a full engineering menu) and EDiTH are diagnostic programs for Webasto and Eberspacher heaters. The program supports virtually all heaters with diagnostic capabilities. In addition to reading and displaying control unit information, you can also access troubleshooting and start-up functions.

FUNCTIONS:

Heater information
Displaying a list of errors (if errors occur)
Clearing the error memory
Overview of heater and component parameters
Graphs of actual component values
Overview of heater performance
Component test
Fuel
Refilling
CO2 calibration
Measured value log
Creating a summary
Visual inspection of the diagnostic line
Running the DTR line program (pin 6)
Writing the eeprom
…etc.

SUPPORTED WEBASTO MODELS

Thermo Top C, E, Handel, P, C/Z MB/DC
Thermo Top C/Z BMW
Thermo Top Audi
Thermo Top C/Z Fiat
Thermo Top PSA
Thermo Top Rover
Thermo Top (98)
Thermo 50 (67339A), (67339B), 90 (C)
Thermo 230/300/350 (E1), (E2), (SG1572)
AT2000/3500/5000
РХх-100/МХх-100
GV/VT 46S, GV/VT 80
W-bus
…and others…

SUPPORTED MODELS

Airtronic M/L
B/D 1/3 C/P Compact
B/D 1/3/5LC, D8LC
D2L, D12V
D7V (D2X)
D9W, hydronic 10
Hydronic 10 M/MII, L/LII
Gidronik 16/24/30/35
Hydronic B/D 3/5 WZ
Hydronic B/D 4/5W SC/S
Hydronic II-H/F, II, II-C
…and others…

HOW TO USE THE ADAPTER

Connect the adapter to the PC.
Install the drivers. Use the correct COM port.
Connect the 12 or 24 volt power supply using the red and black clamps.
Connect the yellow wire to the vehicle’s diagnostic cable or use the connector (for measuring parameters and reading errors).
The switch selects the first or second pin on the 6-pin Webasto connector.

The second switch is used to select the diagnostic program. Blue LED for Webasto Thermo Test (WTT), red LED for EDiTH (auto-detection), and a delay for clearing errors on older heater models.
Select the heater type in the program.